Verified answer

Hi

My friend works at CNA, it's a skateboard industry where they create boards, what they do is a a huge sticker witch have been boiled and heated, so it is very very then, what they do next is pound it on with a mechanical stemper then after it cools down they rub over it with a metal roller so the sticker won't stick, thats about it, hoped I helped.

Hi Alex,

most of the time the prints are hot off-setted. This means the 4-colors (CMYK) are mixed layer by layer so they make the actual picture or logo. They are pressed in (melted together and blended onto the deck) using heat and pressure. Sometimes there is even a finish with a clear lacquer to protect the print.

Check out http://www.ideck.de/ on how to print your own design on a deck!

---------------------------

for all your skateboarding needs.

K d o c k m a i l o r d e r 2 0 0 9

I saw an Element commercial where they put on a logo. I think they have a hot stamp with the logo on it, and either dunk it in the liquid and hit it on, or the stamp is already on and all they have to do it smack it on. But it has to be hot so it's won't come off quickly.

well it starts out in an egg,

once they hatch the boards are than loaded onto a stack of paint.

the paint is evaporated into a carton where they can then lick the ceiling and become heroes

if you be the man you stare the way into my heart and yours

its put through a roller and it puts a really friggin hot stamp on it,and when it cools down theres your design.

P.S Most Skateshops Engrave there logo and then paint it.

Basically they stamp it on, put it in icy water for like 2 seconds, and then they dry it. Then they put a clear coating of paint or masonite on it.

well go to www.cafepress.com