Verified answer

Hola, para ingresar a la Bios siempre es con la tecla F2 en ese tipo de computadoras (sino intenta con DEL o sea suprimir), para cambiar el orden de booteo o unidad de arranque es con F12.

Si te fijas en el manual dice lo siguiente:

BIOS Setup Utility

The BIOS Setup Utility is a hardware configuration program built into your computer’s BIOS (Basic Input/Output System).Your computer is already properly configured and optimized, and you do not need to run this utility. However, if you encounter configuration problems, you may need to run Setup. Please also refer to Chapter 4Troubleshooting when problem arises.To activate the BIOS Utility, press

F2

during POST (when “Press <F2> to enter Setup” message is promptedon the bottom of screen).The default parameter of F12 Boot Menu is set to “disabled”. If you want to change boot device withoutentering BIOS Setup Utility, please set the parameter to “enabled”.Press <F12> during POST to enter multi-boot menu. In this menu, user can change boot device withoutentering BIOS SETUP Utility.

Navigating the BIOS Utility

There are six menu options: Information, Main, Security, Boot, and Exit.Follow these instructions:•To choose a menu, use the left and right arrow keys.•To choose an item, use the up and down arrow keys.•To change the value of a parameter, press

F5

or

F6

.•Press

Esc

while you are in any of the menu options to go to the Exit menu.•In any menu, you can load default settings by pressing

F9

. You can also press

F10

to save anychanges made and exit the BIOS Setup Utility.

NOTE:

You can change the value of a parameter if it is enclosed in square brackets. Navigation keys for aparticular menu are shown on the bottom of the screen. Help for parameters are found in the ItemSpecific Help part of the screen. Read this carefully when making changes to parameter values.

Pleasenote that system information is subject to different models

Dar puntos es agradecer, saludos cordiales.